Test the hand brakes to make sure that they work correctly for both the front and back tire. You should have two light reflectors, two pedals, the bike seat and post, as well as the quick release lever to adjust the seat, some of these items are located in a small cardboard box that comes with the set. First, slide the front reflector light onto the handlebars and tighten it up hyper bicycles using your Philips head screwdriver. Proceed to slide the handlebars onto the bike’s body, it should slide down without any problems. If it gets stuck, adjust the rotating screw at the bottom of the handlebar so that it aligns correctly with the bike’s body and slide it in place. Do both the screw that connects to the body and the other top screw at the top of the handlebars.
So in this guide I will help walk you through assembling the mountain bike with easy to follow step by step instructions. The Hyper eRide mountain bike has been hailed as the perfect companion for younger cyclists looking to get out and explore. At an affordable price, it’s equipped with a powerful electric pedal-assist motor and a 26-inch mountain bike frame.
It is an aluminum frame and the tag that was attached to the bike says that it can hold about 275 lbs or so. I was a bit surprised by this because the manufacturer should have sent us the part since the bike was just ordered brand new and we had the order number and receipt. For a product that would have cost the company a minimum of $10 to ship out, I did find it a bit frustrating that their customer service was so poor and we ended up having to pay for the replacement ourselves. The next problem is that the hyper bike bike seat is hard and uncomfortable, if you only ride short distances it isn’t a problem, but if you do between 2 through 5 miles you will start to feel it. The handlebars sometimes wobble and slide out-of-place, not at the base where it connects to the body, but literally at the center “T” joint at the top near where your hands are, it will slip out-of-place and slide around. I have tightened it a few times and it now finally stays in place, but it can be dangerous when it randomly slides over while riding.
Be careful removing the bike because the box has sharp staples holding it together. Some people recommend using pliers to remove the staples first, but I found it easier to just carefully pull the bike free; do which ever method works best for you. If your handlebars are tangled, proceed to rotate them around either clockwise or counter-clockwise to untangle them. Sadly I cannot give further instructions because it depends on how the handlebars tangle, but if you carefully look it over you should be able to follow the wires to straighten it all out. For those that are new to assembling mountain bikes you may find this article helpful. The instructions that comes with the Hyper Havoc FS Mountain Bike are very basic and show generalized pictures and instructions that sometimes aren’t very helpful.
Additionally make sure your User-Agent is not empty and is something unique and descriptive and try again. If you’re supplying an alternate User-Agent string,
try changing back to default as that can sometimes result in a block. Designed specifically for Time Trial and Triathlon, Corsa PRO Speed promises to revolutionize the racing experience of pro riders and performance-oriented amateur riders. The instructions were not completely helpful for assembling the bike because they were basic and very general, but overall I found it easy to do and I had the entire thing setup in about an hour or so. You can click the above link for detail instructions on how to build this specific bike yourself and all the tools you will need to do so. Proceed to locate the front brake’s screw, it is a silver cap that is connected to a small silver wire on the right side of the brake pad.